Data recovery glossary
Data recovery is the work of getting files back from a device that has failed, been damaged, or had its data deleted or corrupted. The files can still be on the device after the computer has stopped opening them.
These pages are for anyone whose disk, memory card or array has stopped behaving, at home or at work. Each page explains one term that comes up, in plain language, and stands on its own.
Categories
21 terms found.
B
- Bad sector
A bad sector is a small block on a disk that the device can no longer read or write reliably.
C
- Clean room
A clean room is a workspace with filtered air, used when a hard disk drive has to be opened so dust does not settle on the platters.
D
- Degraded array
A degraded array is a RAID array that has lost one or more member disks but can still serve data from the disks that remain.
- Disk imaging
Disk imaging is making a sector-by-sector copy of a storage device so later work is done on the copy, not on the original.
E
- Encryption
Encryption is the process of turning readable data into ciphertext with an algorithm and a key, so that only someone with the right key can turn it back.
F
- Factory reset
A factory reset is an option that returns a phone, tablet or computer to the state it left the factory in, removing your apps, settings and, usually, your data.
- File system
A file system is the method a computer uses to organise files and folders on a volume, and to record where each file's data is stored.
H
- Hard disk drive (HDD)
A hard disk drive (HDD) is a storage device that records data magnetically on spinning platters and reads it with heads that fly just above the surface.
- Head crash
A head crash is physical contact between a hard disk drive's read/write heads and the magnetic platter surface.
- Hot spare
A hot spare is a disk installed in an array and kept powered and idle, ready to replace a failed disk and become the target of a rebuild without anyone swapping hardware.
L
- Logical failure
A logical failure is a problem in the file system, the partition, or the files themselves, while the storage hardware still works.
P
- Parity
Parity is a value calculated from a set of data blocks and stored with them, so that any one missing block can be worked out again from the others.
- Physical failure
A physical failure is damage to the storage hardware itself, such as the heads, the motor, the circuit board, or the platters.
R
- RAID 1
RAID 1 is a way of storing the same data on two or more disks at once, so the array can still be read if one of them fails. It is also called mirroring.
- RAID 5
RAID 5 is a way of storing data across at least three disks so the set can still be read after any one disk fails. RAID means redundant array of independent disks.
- RAID 6
RAID 6 is a way of storing data across several disks with two independent sets of parity, so the array keeps working and loses no data if any two disks fail.
- RAID parameters
RAID parameters are the settings that say how an array lays data out across its disks: the RAID level, the chunk (strip) size, the disk order, the parity layout and the data offset.
- Rebuild
A rebuild is the process where a RAID array recreates all the data from a failed disk and writes it onto a replacement disk, using the disks that remain.
S
- Solid-state drive (SSD)
A solid-state drive (SSD) is a storage device that keeps data in solid-state electronics, usually flash memory, instead of on spinning magnetic platters.
- Stripe size
Stripe size is the amount of data in one full stripe of a RAID array: the size of one chunk multiplied by the number of data chunks in the stripe.
W
- Write hole
The write hole is a RAID fault where an interrupted write leaves a stripe’s data and parity out of step, so a later calculation of a missing block can return wrong data.