Synology RAID 6 recovery: two disks offline, Veeam backups
A Synology DS1817+ NAS configured as RAID 6 and used to store Veeam backup archives stopped working when two of its disks went offline. Some disks had firmware problems and some had degraded surfaces. After those were fixed, every disk was copied sector by sector, the array was reconstructed from the copies, and almost all the data the customer needed was recovered.
| Service | RAID 6 data recovery |
|---|---|
| Drive | Hard drives, RAID 6 |
| Make and model | Synology DS1817+ |
| System | Synology NAS holding Veeam backup archives |
| Symptom | Two disks offline; the device stopped working |
| Diagnosis | Firmware problems and degraded surfaces on the disks |
| Work done | Disk problems fixed, sector-by-sector copies, array reconstructed, file system analysed, custom file-signature rules |
| Outcome | Almost all the data the customer needed |
The NAS and what happened
A Synology DS1817+ with its array configured as RAID 6, holding Veeam backup archives. When two of the array's disks went offline, the whole device stopped working.
What examination established
Every disk was diagnosed first. Some had firmware problems and some had degraded surfaces.
Why the disks were copied first
The repaired disks could still be unstable, so they were copied on specialised hardware before any reconstruction.
What the lab did
- Diagnosed every disk and fixed the problems found on individual disks.
- Copied each original disk sector by sector to working disks.
- Reconstructed the array from the copies, which meant finding all of its RAID parameters.
- Analysed the reconstructed volume to fix problems in the file system.
- Wrote recovery rules matched to the signatures of the Veeam files the customer needed.
Engineer's notes
In this case, we had to create some "tailored" recovery rules to match the signatures of the files required by the customer.
Outcome for this case
The customer received almost all the data they needed.
What this case shows
Two of the array's disks went offline and the NAS stopped. The disks were stabilised and copied before anything else, and the array was reconstructed from the copies, not from the originals. A rebuild inside the NAS would have had to read those same disks, which could still be unstable. Here the Veeam files also needed recovery rules of their own.
What it doesn't show
Why the NAS stopped with only two disks offline: RAID 6 is built to keep running with two missing.
Related: RAID 6 data recovery · Synology NAS recovery · Veeam backup recovery
RAID 6 array failed? Don't start a rebuild, and contact us. No recovery, no fee for most jobs.
Contact R3 Data Recovery
To discuss a data loss incident, contact our team by telephone or submit an enquiry online. An engineer will review your situation and advise on next steps.